Need simple column

[gbrlbll]

Hello carvers!

Need some help finding a pattern for a simple column. Just a smooth even column no flutes or tapers. I want to carve them into the left and right stiles of a corner cabinet, .75 stock 2"wide column 27" tall. I cannot figure out how to do this in my designer and have been unable to locate a pattern to purchase. Any help would be appreciated!

Thanks,

-G

[oscarl48]

Here is a quick plain column that is .75"x2"x27". See if it helps or if it needs to be modified.

O

[SteveNelson46]

There is one in the Pattern Depot for $5.00

http://store.carvewright.com/product...31&cat=&page=1

[gbrlbll]

There is one in the Pattern Depot for $5.00

http://store.carvewright.com/product...31&cat=&page=1

Wasnt exactly what I was looking for, but thank you!

[cestout]

All you really need to do is create a rectangular carved out area about .05 deep any size, and dome it with the horizontal dome then set the height to 999. Make it a group and select the group to make it a pattern. Place the pattern on a board and stretch it to any size you want. That is good in 1.187 with no add-ons.
Clint

[farmer]

Here is one I made in Blender.

[henry1]

Here is one I made in Blender.

to bad its not in 187 or 2 when you made it dam

[SteveNelson46]

Will this help? I did it in Aspire but it can be done in the Designer using the Rail Sweep tool. Michael Tyler has a great video on the add-ons webpage.

http://www.carvewright.com/add-on-mo...tern-modeling/