I replaced my computer a while back and need to reinstall my carvewright software, mostly for the scanning of some of my carvings.
I checked the machine to get the numbers from it and the card that was left in it. Here is what it showed:
Firmware version 1.126
Secondary Revision 7
Firmware build 0123:161657
Here is a list of the updates I've downloaded over the years, though apparently I'm using 1.126 and it was working well on that.
I have the scanning probe as well.
I also have quite a few patterns that I bought.
Any help on installing the software to get back to where I was before the computer replacement would be greatly appreciated.
I was hoping to scan some of the carvings I've done since I changed computers and get them uploaded to the carvewright pattern store.
Thank you. ~Mike Leslie
autobodyman