Carving pattern larger then 13 inches

[svamorgan]

I just bought this carvewright and I'm new to the cnc period. I have some projects that require 20" wide or larger boards but I don't know how to set it up to run multiple boards to do the one design. Can anyone please give an idea how this works thanks so much.

Sent from my SAMSUNG-SM-G900A using Tapatalk

[Dale]

Congratulations on your new machine! If you go to the "Technique" section on the forum and type in "Tiling techniques" in the search block it comes up with many posts on how to do it. I've never done it but it does not seem too hard.

Good Luck

[SteveNelson46]

One project across multiple boards isn't difficult but it does require a basic understanding of the machine and the software. The best advice I can give you is to start off on some simpler projects and learn the basic concepts first. Rome wasn't built in a day.

[DickB]

There are numerous posts on this topic, including one that I did a while ago: http://forum.carvewright.com/showthr...ide#post215613. Also look at the Tips and Tricks: http://www.carvewright.com/assets/ti...icks_Jul09.pdf

[svamorgan]

Thanks for the info.

Sent from my SAMSUNG-SM-G900A using Tapatalk