Originally Posted by
Kix
Hi All, much love.
I'm a couple cocktails in and need to get this down before I lose it.
Has anyone thought of a bit or series of bits that could do your sanding?
Mops are great and all, but if i could finish a project, proof it, then swap the bit to a sanding/buffing whatever terminology works bit, then get back to the phones, email, and harem...?
Thoughts, suggestions, and innuendo are expected.
All The Best.
I don't think you can make the CW unit do the cleaning or buffing??? You need to use the Phone and E-mail later. I made a sanding Mop when I first got my first CW unit. I don't paint my carvings; Some times I use Formby's Tung Oil Finish. I buff it first with my 8 inch Mop on my drill press; running at about 700 RPM's and then buff it again between two coats of Tung Oil. - This work great for me. I got the sandpaper 180 grit from a discount house - a big box of sandpaper.
Last edited by bjbethke; 04-07-2016 at 11:43 AM.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.