Originally Posted by
rnichols
Hello
I was wounding if someone could help me figure out why I keep getting a cut motor error with this simple text plaque. A little back ground on this problem. I have two machines an A model and a C model. I get the same error on both machines. Both machines have less than 50 hours on them. I had the material on a sled with 4 “of “extra” wood on each end. I also added 0.125 (sled thickness) thickness to the wood thinking that for some reason the actual thickness might be throwing things off (never has in the past). I use double sided tape to secure the wood to the sled and put tape over the “seams” on top. I also have tape on the keyboard side on the bottom of the sled. On the C machine I just replaced the rubber belts due to an error on my part. This machine also had the cut motor replaced a while ago, (When new) the project is made with ver. 3.1 I did manage to get the plaques completed by pressing the enter key but would like to know what I was doing wrong for future reference. Another weird thing, when I transfer the project to my laptop to put on flashcard it appears to change Font sizes. Could this be because of the monitor sizes? My desktop will not recognize the card thus the reason to transfer from one computer to the other.
Thank you for any help with this