Restarting after a tool breaks

[kwbcpastor]

Hey guys, I had a tool break the other day and I had already turned the board over to start the other side How do you pick up where you left off? I had to run through the whole first side with out a cutter. Oh I had to taken the board out to remove the broken bit but it was on the first plunge so starting over would not have messed me up if I could have just gotten a fresh start on that side. Any thoughts?

[fwharris]

If it was a 2 sided carve and the back side is finished, just delete the back side design and reload to the card.