Looking for help on what is probably a very simple problem, but for some reason I just can't figure it out. This project is going to hold a near field charging base for my wife's new phone. It will be going into .75" oak.
As you can see, there are several carved regions where the charging puck and phone will sit. My concern is, that I can't find any way to set the max pass depth for them. Being that some of them are .6" deep, I don't want to risk damage to the bit or machine if it 'plunge routes' the area in one pass. So my questions are:
- How can I set Max Pass Depth in a carved region?
- How can I assign the 1/8" cutting bit to that region instead of using the default 1/16" bullnose that will also carve the filigree patterns?
I tried just making the rectangle and circle regions without the carve region setting, but it is just outlining the rectangle and circle. So the only way I know of to get the empty space I need is to carve the region.
By the way, I am using Project Designer 1.187 and I recently updated my machine with the CarveTight spindle.
Thanks for any and all assistance.
Dud