hello everyone, i have attached a project that i am having a problem with. maybe its not a problem and my limited knowledge is just confusing me. i have a 9" circle, in the center of a 12" x 18" board. I want to have arcing text top and bottom, both centered on the y axis so it is centered in the circle. for some reason, it is to the right and cockeyed a little bit. The left side comes closer together rather than being the same amount on both sides. i have noticed it in other projects when needing to have arced text match up to a curve. has anyone else ran into this?? thanks for the help in advance.

navy corpsman.mpc