I'm preparing to do text in a Lithophane. When I go to upload the .mpc, I get a warning the "Carve too deep" for bit selected. Going to the board preferences, the pattern bit is showing 1/16 bullnose bit.
In the .mpc I did the text with a 60 deg. bit. I understand with the 1/16 bit it would be to deep. My question is why in the board preference the 60 deg is not listed? Does this require an add-on feature to show
all possible bits? I'm using Designer 1.187. The material is candlestone (like corian), 8 x 10 x .25.
Any help would be appreciated in understanding this issue.
Text in Lithophane
Reply With Quote