Well, I finally got a chance to finish the candle holders. They were carved out of Myrtle wood using the Rotary Jig and have tapered opposing twists. Each one took 7.5 hours of carving time using the optimal setting and the 1/8" long carving bit.
Well, I finally got a chance to finish the candle holders. They were carved out of Myrtle wood using the Rotary Jig and have tapered opposing twists. Each one took 7.5 hours of carving time using the optimal setting and the 1/8" long carving bit.
Last edited by SteveNelson46; 01-17-2016 at 12:22 PM. Reason: Wording
Steve
Very nice carve and hope some day will have rotary jig but money of ours is to low ,,,Steve you do great work and thx in the past for the help
Henry
Every one has a photographic memory. Some just don't have film.
Great job on them, Steve. I also like the choice of using Myrtle wood. It gives them a great look ....
John
www.jdmwoodworks.com
Facebook Page: click FB button on web page
Bessemer, MI (shop location)
Lake Gogebic, MI (where I hang my hat)
"He who wants by the yard, but gives by the inch, should be kicked by the foot"...
Those are very cool Steve. How did the ends of the carves go? Was there some flexing?
Steve, spectacular pieces. Thanks for sharing.
Wow those are beautiful. Great job.
Heather
I made sure that there was minimal pressure on the sliding plate but there was still a little flexing. It was fairly easy to clean up using a detail sander and some hand sanding. I thought about reducing the center hole from 1" to 3/4" to make the flutes a little thicker but the bit extension that I had was too large in diameter. I also tried to eliminate the hole entirely but the flutes are tapered and the bit didn't go deep enough on the base end.
I'm still having a little problem with the jig at the seam and I may need to send it back to LHR for repair or replacement. It's within hand sanding limits but still a PITA though. Especially in hard to reach areas and on hard or dense woods. Maybe I should test your version of the rotary jig and see if it helps. Myrtle is relatively soft so the cleanup this time was easy. It also has a weird smell. Kind of like mentholated Vicks.
I ordered a couple of Honduran Rosewood blanks for the next set. They were $36.00 each so I sure hope nothing goes wrong.
Last edited by SteveNelson46; 01-17-2016 at 12:12 PM.
Steve
Beautiful work.
Dave
Those are so cool ... I need a lot of upgrades for my machine, and a rotary jig ... Someday I'll hit the lottery ...
Mans Quest for knowledge,,, means he'll always find a way !!
Very unique piece of work!