any Ideas would help

[PDunn]

Just the standard 1/16" tapered carving bit. Just curious why you ask. Do you own any other bits suitable for actual carving?

I also have a 3/16 carving

[mtylerfl]

Ok. You can change the bit selection and take a look at the Designer preview. If it looks alright using that large bit, then go for it. If detail suffers too much, then change back to the 1/16" again. BTW, don't forget to set the pattern Bit Optimization to BEST. The mpc sample I uploaded has NONE (I should have set it to BEST before I uploaded it).