Does anyone have the Texas Star Pattern for 1.187?
Does anyone have the Texas Star Pattern for 1.187?
Bill Noyer
Carving when I can... Gimme a break Uncle Sam
Using Software Version 1.179
Basics Library > Centers
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Thanks Lynn
Bill Noyer
Carving when I can... Gimme a break Uncle Sam
Using Software Version 1.179
Ok... stupid question. Where is that? I can't find the Basics Library.
Bill Noyer
Carving when I can... Gimme a break Uncle Sam
Using Software Version 1.179
I think Connie means a pattern in favorites - basic - star in the Designer program. There is also a star in the depot: http://store.carvewright.com/product...19&cat=&page=1
Thank you. The basic pattern didn't have the "Texas" relief I was looking for. The one in the pattern store does. You guys are the greatest!
Bill Noyer
Carving when I can... Gimme a break Uncle Sam
Using Software Version 1.179
Last edited by bjbethke; 12-05-2015 at 07:49 PM.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.