Great one! To bad it could not be adapted to your phone!
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Nice sign! Should I mention that 'knocking' was misspelled in the last paragraph?
Well I noticed the spelling error after I posted, Canned that one and carved a new one with the correct spelling,
The size was 6 x11 on the original one and the new one was 8 x12. Which came out much better..... BUt notice the size difference on last 5 lines.
IN the original .mpc the last paragraph is one text sequence. i carved a third one and it came out fine. The difference was, on the second one when the machine measured the board length it was a little short from the dimensions on the .mpc file and ask to replace board or adjust the carving. I selected adjust the carving. Apparently there might be a glitch in the algorithms...
I made the third board a little bigger and all went fine.
I sometimes forget to make the board just a little bigger and trim if necessary after carving....
I'll go ahead and asked what everyone is tip toeing around... Could you share the file? I think we would all like to put this at our door.
You did not nice job!
Donnie