I was running the machine today and 80% through a 5 hour carve I heard the cut motor slowing down like it was under a heavy load. Then I got a z axis stall.
I removed the board. cleaned everything up and tried running the project again.
The cut motor did not spin the bit an the machine was oblivious to it.
I ran the cut motor test and that said the cut motor was running when it was not.
I have 281 hours on the machine and I am sure new brushes are in order.
I have a few questions.
Could it be a sensor?
Could it be a faulty board?
Could it be the switch in the cover?
I know this is no one esles problem but I have to get the order done by weekend.... ARGHHH
any help would be appreciated
Thanks Carl