I found this on the net it just misses me up when they use MM instead of standard U.S size, I am wanting to use this with the ER-11.. I assume the 6.D is the 15/64 equal to the 1/4 dia. and the 75L is equal to 2"15/16 length
I found this on the net it just misses me up when they use MM instead of standard U.S size, I am wanting to use this with the ER-11.. I assume the 6.D is the 15/64 equal to the 1/4 dia. and the 75L is equal to 2"15/16 length
R0.5 -> 0.0197" radius ball, 30H -> 1.18" LOC, 6D -> 6 mm diameter - > 0.236" diameter, 75L -> 2.95" total length, 2F -> 2 flutes
You can use this in the ER11M with a 1/4" collect. I have 6 mm collets I use with bits like this. If you buy some, let us know how it goes.
Thanks Dan, I was wanting to make sure before I bought them, last time I ordered a bit I received a .08 diameter bit I have no idea what to use them on, It's so small I am afraid to use it ...But I do have
them
I bought a bit from Kyocera for $29.00 that had english writing on it that I understood and bought that paricular bit I have I used for a total of 80 hrs. and I am still using it... it is like the eveready bunny it keeps going and going..and going...
Did you decide to purchase the bits from Jeefoo? If so, how did they perform?
And where did you pick up the Kyocera bit for $29?
Tracy
World's largest supplier of custom carved firewood.
We use Kyocerca $30 4 flute here is the link
http://www.ebay.com/itm/TAPERED-TOOL...item58cc2436dd
I have not used this type of bit just was trying to make sure that it would fit, for the money, as some one told me there almost disposable...