Originally Posted by
normrichards
Carvewright sells an adapter sleeve which allows you to use 1/4 inch bits in the carve tight. Any standard 1/2 inch bit will fit without an adapter. Keep in mind you can not change the types of bits listed in the software but it is easy to match the bit types with non carvewright bits. In fact half the bits in carvewrights sets use the adapter. I use a white side 1/4 inch to 1/2 inch adapter that is for sale on amazon. It is a little longer than carvewrights adapter but it works. The only problem with carvewrights adapter is the high shipping cost for a very small part.