Ok, I'm making a 2 piece box with lid - Two issues - #1, how can I optimize my design for a faster cut? (Upload in draft mode) #2, and this is the main issue - For some reason (and I can't figure out why), the center carve area (deeper than the larger carve area) for my lid doesn't show as being carved in my designer program the same way the box bottom does. Will it carve out properly as is, or is there something I am doing wrong here?

MPC attached, using Designer 3 with the following : * Version 3 Standalone * Advanced 3D * Conforming Vectors * Dxf Import * Pattern Editor (Probe) * Basic

sgvboxtest1.mpc