Ummm...did I miss something? I just got a whole 14 hours out of these....
Ummm...did I miss something? I just got a whole 14 hours out of these....
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
According to my machine whisperer brother, only 3 things:
Inferior brush material
Overloaded motor
Motor going bad (lots of arcing)
We have CW whisperers on here, so I am sure they will chime in
I showed him my brushes, he thinks they look like Dewalts.. he's gonna check for me
I was already leaning toward a motor, and honestly may just change it out, as I have spares. But inferior brush material??? That doesnt sound quite kosher...
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
Good to share this info guys. Gives me a little education how and what to watch for. Thanks
1800... WOW.. Thanks for the pictures.... THIS is why I look for Cut Motors even if they have a cracked case... You can put a new "er" armature in a case like that after cleaning all the carbon out and you have a new motor.... not much to wear on the case and stator and brush holders if you maintain them.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Inferior materials - carbon mixture off?? He left so I cannot ask.
I knew what you meant. I changed the brushes on the fly and I can hear myself talk in a normal voice, I am pretty sure the motor is shot...
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
A close up picture of the Armature would be nice... Might be a scratch in the copper or a damaged section making it into a "Planer"....
A brush with too soft a mixture of carbon would cause it.... but I can't believe it could slip into the CW Supply chain...
I agree, change the motor... but open the old one for pictures then send as a core to LHR and get another..
Also check the rear motor bearing.
AL
Picture: 1000 hours and a new one.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Just goes to show that with the right care, our little "enthusiast" machines are pretty darn robust
Anyone have any idea when they will have cut motors in stock? Or rebuilds again? Need to order a Y belt so looking to bundle...
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340