Seem like a long tine ago I read that anybody could add a new bit size to "bit selection dialog box".
If this is possible, please direct me to the article.
Thanks
Perry
Seem like a long tine ago I read that anybody could add a new bit size to "bit selection dialog box".
If this is possible, please direct me to the article.
Thanks
Perry
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
It is one off those ideas that pops up once in a while. LHR does experiment with many new ideas but, as far as I know, that one has not yet made it. Maybe what you read was in the wishlist thread?
It's a shame. I walk past all the router bits at home depot and I imagine all the cool stuff I could do with some of them in a carvewright (and I see the bulk of them priced well under $40 for GOOD quality bits), but I can't seem to find the 6° tapered ball end carving bits anywhere. It'd be nice to be able to save some money on bits.