Using blender 3d to create stl for CW pattern

[oscarl48]

A quick pattern made for fun.

[want2b]

Neat, a different round/shell. Hadn't actually seen one to be able to get the proportions. Didn't realize the actual 'bullet' was that large in comparison to the shell casing.

[Mugsowner]

Thanks again Oscar, I think these are the guns they now use out west in the mountians to help bring the snow hazards down in a controlled slide.

[oscarl48]

Thanks gents. And your comments got me thinking so went back and looked. I referenced the wrong image. This is a M4 Howitzer round and not a M107. Same diameter but not sure on the shell size differences.

[oscarl48]

A quick 3d sculpt project for practice and fun.

[want2b]

I'm always amazed by the shading within many of the 'fun sculpts you've posted. Really appreciate them and enjoy the various places your imagination takes you.

[oscarl48]

I wish I could take credit. From the 3d model, I am using the height data to create the height map. So just a few push buttons on the software.

Carvewright designer can do it as well.

[want2b]

Guess the next thing is AI. "Make me a model of a rabbit" Shazaam, bunny ready to carve.

[oscarl48]

lol It's getting there. The results are still a little primitive but a simple bunny should be doable today. Some programs can take text or 2d image and convert them to 3d models.