ribbon or bow

[henry1]

I have been looking for this pattern for a while now , I had my computor crash a few month back got most of my pattern back but this one can't find any help appreciated I did a few with with the CNC ,,does any one have this one on file

[SteveNelson46]

I have been looking for this pattern for a while now , I had my computor crash a few month back got most of my pattern back but this one can't find any help appreciated I did a few with with the CNC ,,does any one have this one on file

I have this one but I'm not sure it is if it is complete.

[henry1]

I have this one but I'm not sure it is if it is complete.

that the right one but don't have the dxf software but getting close

[SteveNelson46]

that the right one but don't have the dxf software but getting close

Henry,
It's already imported to a .mpc

[henry1]

thank you for that

[henry1]

normrichards you have a private message

[normrichards]

I emailed you the files. I tried to attach here but the files were too big. Even though it says dxf in the name you do not need dxf importer, the importing has already been done. I got the files some where on the forum and it was on my to do list, but never have gotten to making one.

[henry1]

I emailed you the files. I tried to attach here but the files were too big. Even though it says dxf in the name you do not need dxf importer, the importing has already been done. I got the files some where on the forum and it was on my to do list, but never have gotten to making one.

thank you I got it thank you again

[henry1]

Henry,
It's already imported to a .mpc

Well steve I tried it and used a 1/8 bit to cut out and its not working for me is there something I am missing like cut out it like its going to cut to big also to cut it saying to deep to cut with 1/16 bit man lost now

[SteveNelson46]

[QUOTE=henry1;251554]Well steve I tried it and used a 1/8 bit to cut out and its not working for me is there something I am missing like cut out it like its going to cut to big also to cut it saying to deep to cut with 1/16 bit man lost now[/QUOTE


Henry,
You need to set the board thickness to .25" or less to use the 1/16" bit.