ribbon or bow

[henry1]

[QUOTE=SteveNelson46;251555]

Well steve I tried it and used a 1/8 bit to cut out and its not working for me is there something I am missing like cut out it like its going to cut to big also to cut it saying to deep to cut with 1/16 bit man lost now[/QUOTE


Henry,
You need to set the board thickness to .25" or less to use the 1/16" bit.

I know what your saying, but the one I used to have the board was 3/4 and I was using the 1/8 cutting bit and not the 1/16 so how do I make it so it will cut the 3/4 board

[SteveNelson46]

Just move them apart a little and use the cut path tool

[henry1]

Just move them apart a little and use the cut path tool

thank you for that well appreciated been here for a while but still learning lol thx again

[eelamb]

Henry I had made that one. Here is the one I posted. Not sure after all this time which one it was but here are all three I had made. I believe # 1 or 3 is the final pattern.
Added instruction page. (someone on the forum had asked me to make this for them, the original is here someplace)

[henry1]

Henry I had made that one. Here is the one I posted. Not sure after all this time which one it was but here are all three I had made. I believe # 1 or 3 is the final pattern.
Added instruction page. (someone on the forum had asked me to make this for them, the original is here someplace)

Man I thank you for that been a while eddie