I have been looking for this pattern for a while now , I had my computor crash a few month back got most of my pattern back but this one can't find any help appreciated I did a few with with the CNC ,,does any one have this one on file
I have been looking for this pattern for a while now , I had my computor crash a few month back got most of my pattern back but this one can't find any help appreciated I did a few with with the CNC ,,does any one have this one on file
Henry
Every one has a photographic memory. Some just don't have film.
thank you for that
Henry
Every one has a photographic memory. Some just don't have film.
Last edited by henry1; 09-19-2015 at 06:44 PM.
Henry
Every one has a photographic memory. Some just don't have film.
[QUOTE=henry1;251554]Well steve I tried it and used a 1/8 bit to cut out and its not working for me is there something I am missing like cut out it like its going to cut to big also to cut it saying to deep to cut with 1/16 bit man lost now[/QUOTE
Henry,
You need to set the board thickness to .25" or less to use the 1/16" bit.
Last edited by SteveNelson46; 09-19-2015 at 07:43 PM.
Steve
Henry I had made that one. Here is the one I posted. Not sure after all this time which one it was but here are all three I had made. I believe # 1 or 3 is the final pattern.
Added instruction page. (someone on the forum had asked me to make this for them, the original is here someplace)
Last edited by eelamb; 09-20-2015 at 07:38 AM.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
normrichards you have a private message
Henry
Every one has a photographic memory. Some just don't have film.