In case ya'll are curious I'm making a door knocker for the front door of my house.... I leave it to your imagination from here.......
In case ya'll are curious I'm making a door knocker for the front door of my house.... I leave it to your imagination from here.......
Last edited by aokweld101; 09-18-2015 at 11:10 AM.
Well, that's a little frightening...lol!
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
like this one I hope? https://www.facebook.com/TheBrizzler...8654017012134/
The tabs were designed to work with "Pierced" and are invisible to a cut path - it will cut right thru them. Since you are ding it deep, try pierced and use the tabs.
Clint
Well I got the pattern to work with the tutorial that Connie posted.. Steve, didn't you have a way to make the pierce wider at the base ?
I'm not sure of what you mean by "wider at the base". I usually outline the pattern and then offset the outlined path by about .25" and then make the offset a pierced carve region. I usually set my tabs to 1/4" wide, flat, and make sure the height of the each tab is below the surface of the edge of the pattern.
Last edited by SteveNelson46; 09-18-2015 at 10:59 PM.
Steve