Just would like to know if improvements have been made in noise reduction.
The proper workbench/table is important re: noise and vibration.
Thanks,
LD
Just would like to know if improvements have been made in noise reduction.
The proper workbench/table is important re: noise and vibration.
Thanks,
LD
Murphy's Law= "Whatever can go will it wrong"
...and "If you think you can do it, or you think you can't do it, you are right." - Henry Ford.
You must have the old spindle, go to carve tight spindle that help a lot
Henry
Every one has a photographic memory. Some just don't have film.
New cut motor CX style.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Henry is right, the CT spindle makes all the difference. I haven't had the oppotunity to hear (or not hear) the CX motor, but with my B and C machines the bit cutting the wood and the dust collector are the main noise.
Clint
Connie I have been checking out a laser engraver for purchase down the road.Was wondering if Carvewright had any plans to add one to the machine in the future Thanks Bert(I would hold off buyiny a stand alone one)
None that I'm aware of.
Last edited by lynnfrwd; 09-11-2015 at 08:34 AM.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Almost as good as the Laser Engraver... The 128 GigaWATT Light Saber Bit.... But the FSC Cable could not handle the power.... and the Flex Capacitor was too big to fit in the machine.
From the back room at LHR in 2008....
(Humor)
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Yes, I remember....
My very old Epilog 25 Watt Laser has sat in the corner un used for years with a "s"... Just too many toys... Had 2 sold the oldest.
Likely the tube is now bad and will need a $2K recharge. It is a old workhorse and worth the recharge.
But my CW is humming away for yet another order of tags making 1.5 x 3 tags from sheet stock while I do the artwork... Life is good...
Speakin of noise... my nearest Neighbor is over a 1/2 mile away and also a woodworker so we both make sawdust noises....
AL
Last edited by Digitalwoodshop; 09-11-2015 at 02:41 PM.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
I've looked into adding a laser bit for wood burning applications (1-3 watt), but we could never sell it because the machine cannot be sealed to the outside.