Good Morning,
I am beginning on a very large project, that ultimately will take four, 40" long boards to carve. I have used the STL importer and sliced my carving so I can use the CW to carve my project.
I inserted the board, the machine measured it:
Keep original size - yes
Place pattern on center - yes
Stay under rollers - no
When it was measuring the board, all was well, until it looked for the thickness, The machine asked "Board thickness ((0, at this point I input "75" I assume this would be for .75 since I did not see a "." on the keypad. The it asked cut-through depth, which again I input "75" again.
Machine went to doing its business of carving a 7+hour carve.
Now it appears that it is carving too deep, and my patterns are not carving as I wanted.
Please tell me what I am doing wrong, as I have never attempted this type of carve.
By the way, the board is supported by 2 aux rollers on both out feeds to support the length.
Attached is a screen shot of the project. I tried to send the MPC, but its file sixe is too big.
Thanks