I have mention this before, variable "angle on draft", just like the custom feather.
I have mention this before, variable "angle on draft", just like the custom feather.
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
Laser attachment!!!
I would like to see the STL import software be able to import files greater than 99000 byes. There are a lot of great carves available that exceed the CW import capability. And yea I do reduce the file but there have been a few cases where the results do not do the CW justice.
I also agree with the previous post for measurement.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Guy T, You may have missed it.... The LASER OPTION was available for a short time but could only be used with the QC and the 18 pin FFC as it supplied the 14.2 Giga Watts that it needed... When they went to a 14 pin FFC they deleted that option...
It was rough on the Bit Flag....
Here is a picture of it operating in 2008... It was only available to buy on one day... 4/1/2008.
AL Who
Last edited by Digitalwoodshop; 05-10-2019 at 04:31 PM.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Al Who; I have not run into any memory card limitations. The largest file (20 hour carve) took significant space but left room for several more carve files.
Some of the STL files that are over sized come back as corrupt file.
thanks so much!
karl
Only on April Fools DAY.... in 2008...
AL Who... Troublemaker...
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com