I'm trying to get this pattern to do a cut path but I just can't figure it out. I want the look of a real rough edged sign but take out the pole on top and bottom. Anyone have suggestions???? TIA
I'm trying to get this pattern to do a cut path but I just can't figure it out. I want the look of a real rough edged sign but take out the pole on top and bottom. Anyone have suggestions???? TIA
I like that but I need the outline of the one I posted or something very similar. I'm using the blank area to put some other things in. Thank you.
You can use a graphics program to erase the post portion and then remove the background from the image. I then filled in with a grey to move it off the bottom and then imported into CW designer. This is what you get. You can manipulate it further if you want to remove more of the board and just leave the jagged board edges.
Here's the outline of your picture.
Suzanne
Thank you all for the help. This is what I'm trying to do. If you have any suggestions to make it better please share.
I sure wish I could see .mpcs and .ptns in tapatalk.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Set the wood sign depth a little deeper to get the edge detail to show better and apply bit optimization best. If you have conforming vectors you should set it for your outline text.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.