New Rotary Litho finished.

[aokweld101]

Never to late to learn a litte more... thank you.

[mtylerfl]

Micheal, I was useing a 3" pipe and had the part off at 3" are you saying that is the way I was to do it ?

Yes, that is correct. Make the part-off diameter the same as the pipe diameter to make sure no carving takes place outside of the desired carving area (in this case the litho photo area).

[dltccf]

Yes, that is correct. Make the part-off diameter the same as the pipe diameter to make sure no carving takes place outside of the desired carving area (in this case the litho photo area).

at 3 inch pipe has a diameter of 3.5 inches.

[mtylerfl]

at 3 inch pipe has a diameter of 3.5 inches.

Unless it was a 3" OD pipe! (ID would be 2.5")