I and many others have been thinking about dovetails for a long time now. I thought I would use my ACB to give it a try. Here is my first attempt using a 1/4" dovetail bit. The cuts were not quite deep enough (x adjustment) and so the pins ended up a little proud. The fit, however, was really nice.
This method has, of course, the severe limitation that the side has to fit vertical in the machine. This limits the technique to making things like small parts or jewellery box drawers.
I used place on end and the machine did not place that accurately on the end. Once tweaked however, the ACB, with the slide in and out feature, could accurately run them off.