Too bad if it is not the problem.
Too bad if it is not the problem.
When swapping FFC Cables be aware that the very old machines had a 18 pin cable and the newer ones are 14. Mix and match and you can burn out the machine...
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Will this work with the older craftsman model? Look a bit different...
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Mine is the older style 16 pin. Does Carvewright still carry them?
Nice catch Al!!
Can one just buy the two boards and the 14 wire FFC or does one have to buy the whole conversion kit with the z motor?