I 'm getting A Z-Axis Stsll Err EO6-0303. Made 7 of the same then started to get this??
Anyone??
I 'm getting A Z-Axis Stsll Err EO6-0303. Made 7 of the same then started to get this??
Anyone??
check your bearing probably binding
Henry
Every one has a photographic memory. Some just don't have film.
It goes to 59% then stops
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Does anything special happen at 59%? Like, does the carve go deeper or wider?
No the error just comes up
yes it stops at same place
I would try reformatting the card and refresher the firmware. It you were running the same project back to back the card might of been corrupted.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Have you tried reformating and reflashing the card? Do you have a DC system? Have you moved the z truck up and down to see if there is a rough spot?