Sometimes it's so obvious

[zan29]

Sorry wrong MPC, use this one since the front is a pattern.

[Bigtyme]

Very nice, Suzanne... Thanks for sharing it....

[henry1]

Here's the MPC and I've used the same thickness as kelsky. Remember it's a two-sided carve and it's for Designer 1.

Attachment 77005

Sorry don't have the 3D to do it

[aokweld101]

I havn't done anything that is 1.5 thick how would you attack it Iv'e been wanting to know that... do you have to slice it to make it work !

[lynnfrwd]

Here's the MPC and I've used the same thickness as kelsky. Remember it's a two-sided carve and it's for Designer 1.

Attachment 77005

I would sure put a ramped up area (Feather - flipped, maybe) on that outer square with a .75" drop-off (cliff) to help avoid breaking a bit.

[zan29]

A 1/4" feather for sure (left it for the users discretion) and you don't have to slice it. Just carve as usual....the bit can handle 3/4" deep just like a pierced carve.
Henry you can still do it, I've made a pattern with it.

[henry1]

A 1/4" feather for sure (left it for the users discretion) and you don't have to slice it. Just carve as usual....the bit can handle 3/4" deep just like a pierced carve.
Henry you can still do it, I've made a pattern with it.

got it thx work good

[bergerud]

This is the kind of thing I would do. Cut out the pocket as opposed to carve it. Make some tabs. Cut out the square...

[aokweld101]

Thanks for that tid bit of information.

[henry1]

This is the kind of thing I would do. Cut out the pocket as opposed to carve it. Make some tabs. Cut out the square...

what was your setting for the 1/8 bit to cut at .094