Jogging to position using 60-degree V bit

[mwunderlin]

I am trying carve some words into a board using the 60-degree V bit but I also want to Jog To Position on the keypad but when I select Jog To Position the only bit choices I have is to use the carving bits not the 60-degree V bit, can you not carve using the 60-degree V bit and Jog To Position or am I doing something wrong?

Thanks for your help
Version 3.102

[bergerud]

The jog to position operation uses the carving bit as a pointer. It will ask you later to put in the V bit. Just go for it, it will work out.

[mwunderlin]

Thanks for the information, I did not go past the part asking for the carving bit so I will give it a try.

Thanks for your help

[zan29]

You learn something everyday, I didn't not know that either!

[rcdages]

Every day we seem to learn something.
That helps us grow.