-
My first three hour carve using 1/4" corian with bit opti at best and carving at .180 went well for the first 2 hours until it happened.
My error of course, I went to see how it was carving, and bumped the table. Snapped it off immediately. wasn't happy. Waited until the next day to make sure I cleaned everything, checked the level of the machine outfeed tables and started the carving again. after 3 hours, extremely happy with the results. Although it was a very costly mistake, it happens to the best of us. And yes, mine was the good old CW with $12 shipping, glad I bought two.
Last edited by Canemaker; 07-06-2015 at 12:17 PM.
Reason: add info
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules