big carve

[aokweld101]

I am in the middle of making a apothecary cabinet for my wife and am not sure if I have this right I have looked at the tutorials and I think it is right if someone has done this type before I could sure use the help.. I was wanting to look like the Magellan chest... thank you in advance...the lines in the middle of the carve are reference points I will delete them afterwards. the drawers are 6.187 height x 5.81 wide.. that will leave me .125 spacing for the drawers .. a total of 18 drawers..

[rcdages]

Quite the project...............

[aokweld101]

Quite the project...............

Yes it is, trying to expand my knowledge...

[henry1]

Yes it is, trying to expand my knowledge...

well can't open just the 2.07 software

[aokweld101]

I will try to change it to 1.87 later.. my bottom is getting sore from sitting so long...lol

[Old Salt]

looks great Keep up the great work
Gary

[aokweld101]

I was waiting on LHR to send me a board sensor but I have no mail comming today since it is a day off for everybody, so I took one off to another machine, my machine is running now and see how I did on my drawings. I had some time think on this and I'm going to have two make two drawings for each board so I won't have a .25 gap in my drawers.

[aokweld101]

I am showing what I have started, I understand now why I could not get an answer on weather I had my drawings right that was a lot of work, but here is what I started, I had made the cabinet to hold the TV set and just used that and started to make the apothecary cabinet so I had a little head start on it.

[aokweld101]

Thank you Dan, I found what I was looking for it say's that it leaves .062 to stay under the rollers don't sound like much is there a way to leave more material ?

[aokweld101]

I finished my drawings for the apothecary cabinet I haven't carved it yet but the measurements add up.