big carve

[aokweld101]

I am in the middle of making a apothecary cabinet for my wife and am not sure if I have this right I have looked at the tutorials and I think it is right if someone has done this type before I could sure use the help.. I was wanting to look like the Magellan chest... thank you in advance...the lines in the middle of the carve are reference points I will delete them afterwards. the drawers are 6.187 height x 5.81 wide.. that will leave me .125 spacing for the drawers .. a total of 18 drawers..

[rcdages]

Quite the project...............

[aokweld101]

Quite the project...............

Yes it is, trying to expand my knowledge...

[henry1]

Yes it is, trying to expand my knowledge...

well can't open just the 2.07 software

[aokweld101]

I will try to change it to 1.87 later.. my bottom is getting sore from sitting so long...lol

[Old Salt]

looks great Keep up the great work
Gary

[aokweld101]

My inside measurements are 20.375 and height and 44.25 long and I'm using .75 boards. this is as close to what I think it should be... my offset will be .062

[aokweld101]

will someone look at my final results and see if I'm attacking this right do I have to turn it to make it work or use a larger board ?

[cestout]

I would use 8.25 wide boards to provide rails for the rollers.
Clint

[aokweld101]

well, 2 3/4 days I finally have the results... I feel good about the drawings and will start when I buy the wood. the files are not in order but it is apothecary 1- 2- 3.