Combining scans, or enlarging scan area?

[kyeakel]

I scanned an object, which worked perfectly. However, I set one of the corners at the wrong location and the scan stopped short of scanning the entire object.

If I scan the remaining section, can I splice it on to the portion already scanned?

Is there a way to tell the carvewright to add the section to an already completed scan? I haven't removed the piece and the probe sits right were it left off.

Is there a way to seam two scans together in the carvewright editor?

It took a few hours to scan this, and I didn't want to rescan the whole thing.

Thanks

[Jeff_Birt]

Short answer, NO. The 'Paste' function does not work at this time , but they say they are working on it.