That's nice ....
That's nice ....
Mans Quest for knowledge,,, means he'll always find a way !!
Maybe I missed something somewhere. I have a laser printer. How is the print we print out put on the board? Do you finish the board before applying or ?
Thanks, Chip
Chip -
Guess there could be different methods to attach the film to the board. I used a spray adhesive on the back side then did a couple of finish coats over the board as usual. I would think anything to keep it in place while you do the finish would work. Doubt that you should do any 'sanding' over the film between coats so a spray lacquer might be a good option for final finishing.
Thanks Mike,
That answered my question. Thanks for the info. Any information on different methods used to get to the end product by forum members is appreciated.
Chip