Finally completed the run of two, new electrical lines for my Carvewright, and DC. Had gotten set up to carve another Litho. I really wanted to do good on this one, also, because it is of my mother. I got everything going, and had to step aside, for a few, as there was something which had to be attended to. When I returned to the carver, it had done enough for me to be able to see that something had been set up really wrong. Either that, or something went totally screwy with my machine. But I BET that it had to do with a miscalculation on MY part. I have attached the MPC file, as well as two photos of what had resulted.