Thanks for the advice...
Originally Posted by
blhutchens
I would recommend using a hardwood, the harder the better. Oak carves nicely with little chip out. I agree with Berg on the 1/32 bit.
I would also save it to the flash on optimal.
Here is one I did recently that was 18" x 24" carved with the 1/16 bit and some of the detail was lost on the logo.
Thanks for the recommendation Brent. I'll give it a shot and post a pick of the results when complete
Warm regards,
--=Garth
It takes less time to do a thing right than it does to explain why you did it wrong.
-Henry Wadsworth Longfellow-