With Designer 3, (or 2) one can use vector groups to cut a line drawing of closed curves with a V bit.
Last edited by bergerud; 03-27-2015 at 08:33 AM.
Just for my info, how did you use the "V" bit to create the different depth, so they appear on the mpc.
I don't see where you assign a bit.
P.S. I did a test on our problem "board too thick" on a 3/4" board , no sled, and it worked ok. Still not understanding why this happens
sometimes and sometimes not. ?????
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
Right click on the vector group in the carving list and click on make vector group and you will see.
P.S. I have asked Metallus to explain what condition invokes the too thick message. I am hoping he will get back to me.
You are the man, I have been trying to think of something to use "make vector group" on and this explains it greatly.
Hope to see you at the conference. in June.
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
I have all the programs to do this type of file but have had no reason to learn it.. I have the DFX and 3.0 program could you tell me what tutoials I need to see to get started.. I do'nt know how to even get the files into the DXF files
One can also make a vector group creation into a pattern.
Last edited by bjbethke; 03-27-2015 at 11:45 AM.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.
Making the image into a font is very cool! How do you do that?
Unable to open bergerud's mpc cause I need designer 3.
I was able to import the image as a dxf then assigned the 90V-groove bit.
Angel90bit.mpc