So today I was at the woodworkers show in NJ and did not see a carvewright booth ... There were several other CNC folks there but no CarveWright ,,, What's up with that ..
Kevin
Middletown, NJ
Member
Somerset, NJ woodworkers show .
So today I was at the woodworkers show in NJ and did not see a carvewright booth ... There were several other CNC folks there but no CarveWright ,,, What's up with that ..
Kevin
Middletown, NJ
Mans Quest for knowledge,,, means he'll always find a way !!
Senior Member
Sounds as if you should of voluntered your services....LOL
Junior Member
On my way there thru the frozen tundra tomorrow morning. I was also at Baltimore and I don't think they were there either. Weird...a couple years ago I thing they sold a ton of units
Machine Model C.
I believe I'm using the CarveTight chuck, the one with the red handled hex wrench
Unit was bought in 2011.
As of Oct 2013, have logged around 250 hours
Using the heavy duty rubber drive belts.
Using the Ringneck blues DC with a Harbor Freight dust collector
Member
Had I have known I may have done it ... And yes it did start snowing pretty good around lunch time .. But it did get warm, we got upto 20 or so which was nice when you consider that we been in Neg temps ... Be careful driving up tomorrow as we are suppose to have an ice storm along with the snow ... I'll be back too tomorrow ...
Mans Quest for knowledge,,, means he'll always find a way !!
Posting Permissions
Reply With Quote