Updated to 3.102

[edsingletary]

If Connie is looking, downloaded the recommended update. Now I have an issue with a couple of things. First I can't use pattern editor, says demo mode only. Goes to Pattern Sculptor, which I don't have. Then, I don't see import a tracing image only import image file for making a pattern .

Help, Thanks

I did the license update thing and all the purchased patterns etc. show up.

[lynnfrwd]

OK...I'm looking, but this would be much easier and quicker over the phone. 713-473-6572 (Operator is standing by....)

[lynnfrwd]

What operating system is your computer?

Is this "MAIN" or "LAPTOP"?

Did you use Run As Administrator?

On Pattern Library, right click and see drop down menu, where you should be able to select Open with Pattern Editor or Open with Pattern Sculptor (default, if double clicked).

[edsingletary]

What operating system is your computer?

Is this "MAIN" or "LAPTOP"?

Did you use Run As Administrator?

On Pattern Library, right click and see drop down menu, where you should be able to select Open with Pattern Editor or Open with Pattern Sculptor (default, if double clicked).

Thank you Connie, called and Chris got me on the right track.

[lynnfrwd]

Thank you Connie, called and Chris got me on the right track.

Good deal.

[ladjr]

Connie
Here is a funny one. Every time I load Carvewright program, it also brings up browser to your web site.

Leo

[bergerud]

Thank you Connie, called and Chris got me on the right track.

For future reference, what was the problem?

[fwharris]

Every time I've done updates, even the original install, of 3.xxx I've gotten the same thing with saying it is not registered. What I've done is to do the update license from the help tab. After that all works just fine.

[lynnfrwd]

Going to browser, because you selected automatically check for updates. It means you don't have latest version yet. Surprised me the first time, too.

[lynnfrwd]

Floyd, that may be the Run As Administrator command wasn't done.