Results 1 to 7 of 7

Thread: Depth question

  1. #1
    Join Date
    Mar 2008
    Location
    Punxsutawney Pa.
    Posts
    93

    Default Depth question

    Depth question
    I see that the minimum diameter for the rotary jig is 1 inch but I cannot find any information on the smallest finished diameter. Could you carve down to a ½ inch or smaller?
    Thanks,
    Denny

  2. #2
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    I think you can carve it all away if you want! It is only a problem of support. If you carve too much away, it will break.

    I do not think there really is a minimum. The dowel diameter is not measured by the machine, and so, I do not see how it could know if you had a 3/4" dowel.

  3. #3

    Default

    Looking for a beer bottle pattern for rotary jig Thanks Bert

  4. #4
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    That is pretty easy to make with extrude. If you do not have the 3d add on, show me a bottle. (Designer 2 or 3?)
    Attached Files Attached Files
    Last edited by bergerud; 07-18-2015 at 08:43 PM.

  5. #5

    Default

    Perfect/ need it for Designer 2 Thanks Bert

  6. #6
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    I made the extrude into a pattern in case you do not have the 3d stuff.
    Attached Files Attached Files

  7. #7

    Default

    Thanks again ( I don't have 3d) Bert

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •