And if you use a sled or even on a board only, if the board or sled comes out from under one roller then it can lift and bind the cutting bit and cause a snap.
So design things to ALWAYS be under 2 rollers while cutting.
AL
And if you use a sled or even on a board only, if the board or sled comes out from under one roller then it can lift and bind the cutting bit and cause a snap.
So design things to ALWAYS be under 2 rollers while cutting.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com