Hi you all!!
I got myself a scanning probe, made a sled and laid out part to scan. I set my depth but the probe will not raise up. It just runs into the side of the part.
What am I doing wrong?
Hi you all!!
I got myself a scanning probe, made a sled and laid out part to scan. I set my depth but the probe will not raise up. It just runs into the side of the part.
What am I doing wrong?
There is a video and downloadable instructions under Carvewright support. These items may help.
Dbemus
Thank you. I watched the video so I will check out the download.
Give ya a little pointer about using the probe. The metal tip WILL scratch things up. There is a thread on here that talks about using a glue tip made by Testors, I got mine from Hobby Lobby and it does help a lot. Just a suggestion if you are trying to copy (scan) something that is precious.
CarverJerry
ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.
Thanks Jerry. I read that. Any ideas why the probe is not scanning
You take care and have a good one.