I'm hoping this is a dumb question. I have the new rotary jig and software, 3.0 designer, 3d modeling, pattern sculpture and more...How does one take a 3d model (like Ed Lamb's Madonna post on 3/25/14) and "unwrap" it to make a rotary carve project? I've reviewed the software tutorials and past posts on the forum and although it's mentioned I haven't found any information on how that's done.

I'm assuming it takes other software programs or 3d model files to generate the 3d model to begin with....but how it's made into an "unwrapped" design that the rotary software can carve is the question...

Thanks!