Ribbon Scroll

[dehrlich]

Does anyone have a pattern of something like this, or can you make a good clean pattern of this one? I did what I could but the edges are jagged. Want to use this on top of a jewelry box. Thanks!

[PDunn]

there is a scroll on the front of this plain Jewelry box u can cut and paste if it helps plain jewely box [mom}.mpc

[dehrlich]

there is a scroll on the front of this plain Jewelry box u can cut and paste if it helps plain jewely box [mom}.mpc

Thanks my friend. I got a few like that already... the one pictured is something the customer really likes so wanted to use that if possible. Thanks again

[americanhonor]

Thanks but the ranger scroll is a little different

[CW-HAL9000]

here is one that I got from the forum at one time or another. In 1.87

[dehrlich]

I think my thread got hijacked... I don't need a ranger scroll LOL I just wanted to see if someone could make a clean pattern from the pic I posted. Anyone?

[cestout]

I have a ribbon scroll in the Pattern Store. I created it by using the 2D Suite to out line it and the 3D Suite to extrude the surfaces. It was fo a project that someone wanted but didn't want to pay for the work to create it. Takes time an patients. Your scroll would be harder because it goes much deeper on one end.
Clint