carving a line

[shasta]

this feels like an extreme newbie question because it seems like it should be simple, but im trying to make a little sign and want to have it inside a square line carved around the outside. cutting a sqaure is easy, shouldn't just carving it be as well? been searching forum for an answer, no luck, internet too slow for videos on carvewright tutorials

[myshop1044]

Attach your project so we can see and help.

[CW-HAL9000]

Draw the line you want just like you would if you were going to make it a cut path. Then right click on the line and choose select bit and select the bit you wish to use. Then choose height and depth. I think this is what you are talking about. let me know if I am wrong.

[shasta]

Draw the line you want just like you would if you were going to make it a cut path. Then right click on the line and choose select bit and select the bit you wish to use. Then choose height and depth. I think this is what you are talking about. let me know if I am wrong.

thats it thank you so much...is 1/16th ballnose the carving bit?

[Dale]

Yes it is.